SPE Drilling & Completion
Volume 27, Number 1, March 2012, pp. 145-157

SPE-150001-PA

Fracture and Fatigue of Polycrystalline-Diamond Compacts

View full textPDF ( 1 KB )

DOI  More information 10.2118/150001-PA http://dx.doi.org/10.2118/150001-PA

Citation

  • Zacny, K. 2012. Fracture and Fatigue of Polycrystalline-Diamond Compacts. SPE Drill & Compl  27 (1): 145-157. SPE-150001-PA. http://dx.doi.org/10.2118/150001-PA.

Discipline Categories

  • 1.2.1 Bit Selection, Performance
  • 1.2.3 Torque/Drag Modeling, BHA Performance Prediction
  • 1.2.5 Materials Selection (Casing, Fluids, Cement)

Keywords

  • polycrystalline diamond compact, PDC, wear, fracture, drill bit

Summary

Four different batches of polycrystalline-diamond compacts (PDCs) were tested under monotonic and cycling loadings. Initially, the mean load to fracture was recorded for each batch. In fatigue tests, the specimens were preloaded to between 75 and 95% of a batch mean static (S) strength and the R-value of 0.1 was used with frequencies of 10 and 20 Hz. It was found that some PDCs sustained greater than 106 cycles without fracturing. It was also noted that fracture force was reduced by 10 to 35% after the specimens were subjected to cyclic loading. This could indicate that fatigue weakens the structure of the PDC material. Tests conducted on two opposing edges of the same PDC buttons showed that the fracture on one side does not affect the strength of the opposing side. Thus, PDCs whose fracture or wear on flat areas is relatively small can be salvaged from the old bits, rotated 180°, and then rebrazed. Investigation of the fracture surface using a scanning-electron microscope (SEM) revealed that the fracture followed a transgranular path.

© 2012. Society of Petroleum Engineers

View full textPDF ( 1 KB )

History

  • Original manuscript received: 28 March 2011
  • Revised manuscript received: 26 May 2011
  • Manuscript approved: 6 June 2011
  • Published online: 27 February 2012
  • Version of record: 15 March 2012