SPE Journal
Volume 16, Number 1, March 2011, pp. 55-64

SPE-130050-PA

Interfacial Stability of In-Situ Bitumen Thermal Solvent Recovery Processes

View full textPDF ( 684 KB )

DOI  More information 10.2118/130050-PA http://dx.doi.org/10.2118/130050-PA

Citation

  • Sharma, J. and Gates, I.D. 2011. Interfacial Stability of In-Situ Bitumen Thermal Solvent Recovery Processes. SPE J.  16 (1): 55-64. SPE-130050-PA. doi: 10.2118/130050-PA.

Discipline Categories

  • 6.4.10 Steam-Solvent Combination Methods
  • 6.4.9 Steam-Assisted Gravity Drainage (SAGD)
  • 6.4.5 Thermal Methods (e.g.,Steamflood, Cyclic Steam, THAI, Combustion)
  • 6.9.4 Oil Sand/Shale/Bitumen
  • 6.4.6 Chemical Flooding Methods Methods (e.g., Polymer, Solvent, Nitrogen, Immiscible CO2, Surfactant, Vapex)

Keywords

  • steam assisted gravity drainage, SAGD, ES-SAGD, bitumen, steam chamber

Summary

Expanding-solvent steam-assisted gravity drainage (ES-SAGD) is an in-situ steam/solvent recovery process to produce heavy oil and bitumen from oil-sands reservoirs. In ES-SAGD, steam and solvent are injected into the depletion chamber within the reservoir. At the chamber edge, the steam releases its latent heat, heating the oil there, and solvent mixes with mobilized bitumen, which then flows under gravity to the lower horizontal producer. Many factors influence the efficiency and rate at which oil is mobilized. One of them is the stability of the steam/oil interface, which is controlled by the concentration and temperature dependencies of viscosity and density and the relative magnitudes of viscous, gravity (buoyancy), and capillary forces. In this research, the stability of the chamber interface between the vapor chamber and the bitumen at the edge of the chamber is examined. We present theoretical evidence for occurrence of such instability and conditions at which the interface is unstable. The results demonstrate that steam/solvent injection enhances the instability of the interface, thus promoting greater mixing at the edge of the chamber. Consequently, the oil rate of a steam/solvent process is higher than that of a steam-only process. Therefore, there are three fundamental contributions to enhanced production by solvent/steam processes. First, the oil-phase viscosity is lowered. Second, the oil saturation is enhanced at the edge of the chamber. And third, the vapor/oil interface becomes more unstable, which promotes more mixing at the chamber edge. The stability of the interface is also controlled by the balance between the solvent's solubility in the oil phase and the ability of the solvent to reduce the viscosity of the oil phase. The results of the stability analysis confirm the findings of laboratory experiments and field tests, which demonstrate that processes that use solvent/steam yield higher production rates than those that use steam alone. The analysis also reveals that there is an intermediate solvent between the lightest and heaviest ones where the instability is maximized, which further explains peak oil rates for intermediate solvents obtained from steam/solvent experiments (Nasr and Isaacs 2001).

© 2010. Society of Petroleum Engineers

View full textPDF ( 684 KB )

History

  • Original manuscript received: 1 March 2010
  • Meeting paper published: 25 April 2010
  • Revised manuscript received: 6 May 2010
  • Manuscript approved: 29 June 2010
  • Published online: 11 November 2010
  • Version of record: 15 March 2011