SPE Journal
Volume 17, Number 4, December 2012, pp. 1231-1245

Summary

Creation of low-mobility foam for enhanced oil recovery (EOR) is triggered by an increase in superficial velocity; thereafter, injection rate can be reduced to lower values, and strong foam remains at velocities at which weak foam was previously observed. Here, we consider whether strong foam created near an injection well can propagate to large distances from the well where superficial velocity is much smaller. We study strong-foam propagation with finite-difference simulations and Riemann solutions, applying a population-balance foam model that represents the multiple steady states of foam.

Our simulations show that strong foam cannot displace directly the initial high-water-saturation bank initially in the reservoir at low superficial velocities; it pushes a weak-foam state with lower velocity that in turn displaces the bank ahead. Our traveling-wave solutions show that strong foam propagates more slowly as superficial velocity decreases and stops propagating at yet lower superficial velocities, in agreement with the experiment. Failure of propagation occurs at superficial velocities greater than that at which the strong-foam state disappears; it raises concerns for long-distance propagation of strong foam created near the injection well. In the context of the model, it is not extraordinary destruction of foam at the front that slows the propagation of strong foam, but failure of foam (re-)generation at the front. Our model also represents for the first time a process where strong foam is created near the exit of a core and then propagates upstream, as seen in some experiments.

© 2012. Society of Petroleum Engineers

View full textPDF ( 2,522 KB )

History

• Original manuscript received: 23 November 2011
• Meeting paper published: 14 April 2012
• Revised manuscript received: 14 May 2012
• Manuscript approved: 11 June 2012
• Published online: 5 December 2012
• Version of record: 6 December 2012