Separator Design and Troubleshooting


Project Facilities and Construction

Description

This 2 day course describes different types of separators and scrubbers for a desired performance, how to design, and how to troubleshoot and debottleneck.  Discussions will begin with descriptions of two and three phase separators.  Internals for enhancing separation performance will then be explained.  The course then continues with fundamental separator/scrubber design principles including level control and effects of motion and inlet piping on performance. A significant portion of the course covers troubleshooting and debottlenecking examples of separators and scrubbers.            

Topics discussed will be:

  • Different types of Separators and scrubbers
  • Different types of separator and scrubber internals
  • Theoretical sizing of separators and scrubbers
  • Effect of inlet geometry on separation performance
  • Case histories

At the end of this course, participants will be able to:

  • Identify, understand and select different types of separators for a desired service
  • Identify, understand and select different types of internals for a specified performance
  • Understand and discuss the theoretical basis for sizing separators
  • Understand level control settings and their effect on separator performance
  • Design a two or three phase separator/scrubber          
  • Troubleshoot separation problems in the field

Learning Level

Introductory to Intermediate

Course Length

2 Days

Why Attend?

Poor separator or scrubber design can degrade the entire fluid processing system and lead to offspec. oil, gas and/or produced water as well as equipment damage and unplanned shutdowns. This course will give you a better understanding of separator and scrubber designs to eliminate or minimize rework or shutdowns and optimize production and the efficiency of processing facilities.

Who Should Attend

Engineers that are involved in designing, operating, and evaluating gas/liquid/liquid separators and scrubbers. This is an introductory to intermediate course for Engineers (including new) in oil and gas industry process separation.

Special Requirements

  • General facilities knowledge
  • Calculator (or laptop)
  • Attendees need to bring relevant field applications and problems to use for in-class discussions

CEUs

1.6 CEUs (Continuing Education Units) will be awarded for this 2-day course. 

Cancellation Policy

All cancellations must be received no later than 14 days prior to the course start date. Cancellations made after the 14 day window will not be refunded.  Refunds will not be given due to no show situations.

Training sessions attached to SPE conferences and workshops follow the cancellation policies stated on the event information page.  Please check that page for specific cancellation information.

SPE reserves the right to cancel or re-schedule courses at will.  Notification of changes will be made as quickly as possible; please keep this in mind when arranging travel, as SPE is not responsible for any fees charged for cancelling or changing travel arrangements.

We reserve the right to substitute course instructors as necessary.

Full Regional cancellation policies can be found at the “Cancellation Policy” link on the SPE Training Course Catalog page.

Instructors

Robert Chin, Padden Engineering

Co-founder of SPE’s Separations Technology Technical Section; primary author/editor of the Savvy Separator series in SPE’s Oil and Gas Facilities Magazine. Updated subsea pumping/processing and advanced subsea equipment research and development 5-10 yr strategies for major oil company.

Victor van Asperen, TechnipFMC.