Designing an Optimized Surfactant Flood in the Bakken

Getty Images

The Bakken is one of the most prolific plays in North America, but, even with the deployment of horizontal wells and hydraulic fracturing, anticipated recovery factors under primary depletion are usually in the range of 10 to 20%. Waterflooding has been a commonly deployed technology in conventional reservoirs to enhance recovery beyond primary depletion. However, the Bakken’s ultratight, largely oil-wet nature limits the potential of waterflooding. As an alternative, an optimally spaced well-to-well surfactant-flooding technology is proposed.

Introduction

Recent studies focusing on wettability alteration by use of surfactant in the Bakken have shown strong potential. Spontaneous-imbibition tests in Bakken cores show recovery factors that can exceed 30% and sometimes achieve up to 60%. However, in an ultralow-­permeability system, the rate of surfactant imbibition is perhaps more important than the ultimate recovery factor. Initial studies show potential, but to achieve an economical surfactant recovery process, ultrahigh imbibition rates must be achieved. In addition to the technical challenges associated with stability, compatibility, and injectivity, economical deployment of surfactant in a marginally profitable play such as the Bakken is another major challenge. To minimize the surfactant required for a successful process, a surfactant would ideally have an ultralow critical micelle concentration (CMC) and low adsorption while maintaining key performance indicators that are discussed in the complete paper.

This article, written by JPT Technology Editor Chris Carpenter, contains highlights of paper SPE 175937, “Designing an Optimized Surfactant Flood in the Bakken,” by Matthew Dawson, Statoil; Duy Nguyen, Nalco Champion; and Huina Li, Statoil, prepared for the 2015 SPE/CSUR Unconventional Resources Conference, Calgary, 20–22 October. The paper has not been peer reviewed.
...
This article is reserved for SPE members and JPT subscribers.
If you would like to continue reading,
please Sign In, JOIN SPE or Subscribe to JPT

Designing an Optimized Surfactant Flood in the Bakken

26 December 2015

Volume: 68 | Issue: 1

STAY CONNECTED

Don't miss the latest content delivered to your email box weekly. Sign up for the JPT newsletter.